10. A request in terms of subsection (1) of section seventeen for the
post-dating of an application shall be made in Form No. 8.
Request for
post-dating an
application
PART III
DRAWINGS
11. Drawings, when supplied, shall accompany the provisional or
complete specification to which they refer, except in the case provided
for by regulation 18. A true copy of the original drawings shall be
lodged at the same time as the original drawings.
When supplied,
drawings to
accompany
specification
12. (1) Drawings shall be made on pure white tough drawing paper, not Drawing paper
thinner than 100 sheets to the inch, of smooth surface and good quality,
and without colour or washes, in such a way as to admit of being clearly
reproduced on a reduced scale by photography.
(2) Mounted drawings may not be used.
13. (1) Drawings shall be on sheets which measure 13 inches from top Size of sheets,
to bottom and are either 8 inches or 16 inches wide, and shall be made etc.
on one side of the paper only and have 1 1/2 inches clear binding margin
on the left-hand side of the sheet and a 1/2 inch clear margin on the top,
bottom and right-hand side of the sheet.
(2) If there are more figures than can be shown on one of the smaller
sized sheets, two or more of these sheets shall be used unless the large
size is required by the size of any one figure.
(3) An exceptionally large figure may be continued on subsequent
sheets.
(4) No more sheets shall be employed than are necessary.